Wayne-dalton IDRIVE 9900 Manuale Utente Scaricare il pdf

TorqueMaster™ & idrive™

9900/9600/9200/9100

INSTALLATION INSTRUCTION

SUPPLEMENT

When installing an idrive™ opener with this door use

this supplement to the main door instructions as follows:

1) Begin with Step 1 of the main door instructions.

2) Replace Step 8 of the main door instructions with

Step 8 of the attached supplement.

3) Replace Steps 12 through 17* of the main door in-

structions with the Steps 12 through 17b of the attached

supplement.

*Supplement replaces Steps 12 - 18 on single spring doors

1 2 3 4 5 6 7 8

TorqueMaster™ & idrive™9900/9600/9200/9100INSTALLATION INSTRUCTIONSUPPLEMENTWhen installing an idrive™ opener with this door usethis supplement to

®Follow the corresponding steps in this insert with the steps in the installation manual provided with the door. Thesemodifications are designed to a

TORQUE TUBEPLUG MOTORINTO THE OPENERPOWER HEADSLIDE OPENERPOWER HEADLABEL(LEFT SIDE)TORQUETUBEINSERT THIS END FROM LEFT SIDE OFOPENERContinue sliding

Refer back to the main door manual and continue door installation at theREAR SUPPORT INSTALLATION Step 18. (Step 19 in the Single SpringTorqueMaster™

Drum InstallationTORQUE TUBEWINDING SHAFTDRUMTORQUE TUBELOOSE WINDING SHAFTDRUMWINDINGSHAFT GROOVEROUNDNOTCHFLAG ANGLEShake the torque tube gently to

Using the emergency disconnect, pull disconnect handledownwards and place it in the manual door operatedposition. Use disconnect label for reference.

Slide the right hand end bracket over the drive gear. Attachend bracket and the flagangle to the jamb with (2) 5/16 x1-5/8” lag screws. (see Fig. 11

power head. With slack removed, secure bottom of handlebracket with (1) 1/4 x 1-1/2" lag screw.CAUTION: Pull handle just enough to remove the c

Nessun commento

Wayne-dalton IDRIVE 9900 Manuale Utente